X3 Analyze Bug?

[Jim at Gentex]

I just discovered a problem with the analyze function in X3.

 

I have 5 points along the Y axis of a model at X zero.

 

When I use Analyze>Position, Mastercam reports all 5 points at X0.

 

When I use Analyze>Entity Properties, Mastercam reports all 5 points at X-0.0004

 

There are no duplicate points, and the Settings>Configuration>Analyze are both set to N.1234, so the X-0.0004 value should show using either, should it not?

 

I opened the same model in X2MR2 and found that the Analyze>Position and Analyze>Entity Properties both show the points at X-0.0004 as they should.

 

Is this a bug in X3?

 

Thanks.

[Slydman]

What are your system tolerance in your config file?

 

tolerance setting should be smallest as possible (mine is 0.000001)

[Jim at Gentex]

That was it Slydman!

 

Thanks.

[Jim at Gentex]

That was it Slydman!

 

Thanks.

[Slydman]

You're welcome