What happened to Mill ref. return??

[Randy Morton @ Clem Industrial]

I have not done any strickly MILL programming in about 2 years. I was wondering what happened, or if I am dreaming, to the REF Return in a MILL MD?

 

At any rate, I am getting a post out of this

 

 

G1 X-6.519

G0 Z2.

G91 G28 Z0.

G0 G90 B270. X3.7357 Y4.32

Z2.

Z.81

G1 X-.7357

 

Specifically I am looking to change the G91 G28 Z0. to something like G0 Z10. (already in G90)... So I thot the Ref. Return would be be swell, but I cant seem to find it....?

 

Edit: I just checked another office computer that still has X3 on it, and sure enough on the TP Paramaters page, first tab, it is there. Called Ref. Point, bottom right corner....

[Joe788]

It's a branch under linking parameters, in the tree on the left.

[Randy Morton @ Clem Industrial]

Oh very good! Thank you Joe... I musta be blind!

[Joe788]

Don't feel bad, when I switched to X4, I spent an hour trying to find Helical Entry in a pocket toolpath!