Davinci stepper router set up trouble

[striper26]

I recently upgraded to mastercam X from 9 and can't seem to get the router to talk to the software. I get a run time error if I try to make a pocket.

 

I think I have the wrong machine type selected but I am not sure which one will allow the isel davinci table top router to operate properly.

I have a techno post processor.

Any idea which machine type to select?

[Will Slota]

My first guess is yout tool is not defined as tool number one.

[Todd Tracey from Fastech]

Did you update the V9 Post to create the required Machine Def, Control del, and post for X? Most of them were set up to run with Mill. If you have an educational seat, try looking under Router as there is a Machine Def there by default.

Other wise, you might try going to www.technocnc.com