Using Simplify from VB????

[Scuba Jon]

Is there a way to call the Edit/Simplify function from a VBS in X2? I want to search through all the elements on a given level for arcs with a common center point which when combined make a full circle (360 degrees). My problem is that some of the my arcs are coming in as splines so I want to change them to something I can look for.

I know - too much information. I should have quit writing after my initial question.

 

[Colin Gilchrist]

code:

---

 

' -- Start Script

Call Main()

 

' ////////////////////

' Sub Declaration

' ////////////////////

Sub Main()

Call RunMastercamCommand("simplify")

End Sub

 

---

[Scuba Jon]

Thanks Colin

That works but I was hoping to run this without the user having to provide any additional input. The simplify bar shows up in the screen when the VB calls it and required the operator to click on the green check to proceed. I know that is pretty simple but the crew I am writing this for will do nothing but complain if I leave stuff like that in it. Does anybody know of a way to run simplify without having the additional user input?