Prereading NCI file & Modifying Post output

[Scuba Jon]

X4 MU3 Router

 

Hi all

I have a post question that I could use some guidance on. During posting, I would like to find all the Toolpath/Point operations with a specific canned text attached to them, record the x,y & z values of that Point operation and then output this information at the beginning of the NC output regardless of where they actually occurs in the program. There could be several places within one program where these occur. I suspect I will have to capture this while reading the NCI file but do not see how to do this. Any help will be greatly appreciated.

[Günther Massimo - GMCCS]

You can write them to the main file while posting. All other operations can be written to a subfile.

Merge them and you are done.

No need to read the nci in advance.

[Scuba Jon]

Günther

Thank you for the help. This appears to be working. It tool a little doing because I have never used a subfile before but once I figured out all the syntax I started getting the results I was looking for.

Danke schön!

[Tariq Aslam]

@Scuba Jon, could you share the code on how you achieved it