Curve 5 axis question?

[Mcam Nut]

I machined a corner rad in the bottom of a deep slot with the tilt angle set to 15 deg to clear the tool holder. I had to mill the rad on both sides of the slot, so I used 3-d curves for cut param, and surface for tool control. In verify, and backplot this worked great, but wouldn't work when posted on the machine, nothing would seem to fix the problem until I removed one of the chains, and post each side separably. I think I posted multi curves in one operation in the past, but can only post i curve at a time now. Is anyone else having this problem? Machine is a DMG DMU80T.

[Tyler Robertson]

Try changing the order that you do the cuts - could be the direction your machine is trying to turn

[Mcam Nut]

I tried that Tyler, it worked fine in verify, but not on the machine. I am wondering if maybe it has somthing to do with the updateed post? I am going to program the same part in x4 later, and see if it works