Mill.set files

[Rick46]

I was doing some work on updating a old post and creating a machine definition file along with a control definition file and I noticed it modifed my mill.set and mill2.set files in my post folder. I deleted them completely because it said there were errors on certain lines with them when updating a old post and files associated with it.. I thought I could just restart the session and they would recreate them by default. I have done this with my system config file before just rename it and it creates a new default one when MC is started.. but my questin here is how do I get the original .set files back because now they are gone.. are they important.. not sure what role they play as far as mastercam goes..

 

thanks,,.

[Paul Decelles]

You do not need them if you are not using them. .set files are used to create setup sheets or tool lists when they are enabled in system config. You can grab them off of your installation disk or I am sure your dealer can email new copies to you if you do decide that you need them.