arc output for surface finish on ID dia.

[canyoneer]

I can not get X5 to output arcs for an inside diameter surface contour approx 5 inch dia. Leaving 0.0 on finish, with no check surfaces. I have tried everything filter wise and it will only post lines. My boundary is an arc, well away from the surface. This is a nurb surface.

MPMASTER post and or MPFAN. I can get arc out put in version 9. Am I doing something wrong filter wise?

 

Thanks,

Jim near Boston

[Guyinthedesert]

Go to your Control definition, under Arcs, make sure Arc output is enabled

[canyoneer]

I am still having no luck with this issue. My arc settings are good to go.I do get wire frame to post out arcs. I have created a cylindrical ruled surface using 2 arcs and still the same results.

 

Any more ideas?

 

Thanks

Jim near Boston

[Guyinthedesert]

I am still having no luck with this issue. My arc settings are good to go.I do get wire frame to post out arcs. I have created a cylindrical ruled surface using 2 arcs and still the same results.

 

Any more ideas?

 

Thanks

Jim near Boston

 

Under Total Tolerance, is your filter setting on with Arcs enabled?

[canyoneer]

I must have gone stupid. Thanks for setting me forward Guyinthedesert.

Jim near Boston