v8.1 verify DIES!

[5-axis]

Last week we updated our two seats from v6 to v8.1. All is well until we start to run verify.

As soon as the verify screen opens we get a warning as follows:

Failure: in stock definition.

I am not new to Mastercam nor v8. I have used Mastercam daily since 1990, v3 through v8 at other places I have worked as well as my own contract business.

All the params are setup fine and this is only happening on one PC.

Dell XPS T500, 256MB

Diamond Viper V770D Ultra 32MB, latest drivers, haves slowed hardware acceleration one notch at a time with no improvement.

Once the warning box is closed, Mastercam is aborted.

[ProductDevelopmentGuy]

Go to the MILLOPS subdirectory. Do SIRIUS.PRM and/or VERIFY.PRM exist there? If so, delete them. It sounds like it's trying to use the values from a previous session.

[5-axis]

PDG,

Thanks, that seems to have remedied the prob.