Contour 2D - Post processing issues

[TK-32™]

Hello folks,

here's one that I can't figure out. It's this warning I get when trying to post a program.

I don't have depth cuts in this toolpath. Has anyone run in to this yet?

If I click CANCEL it makes the bad operation dirty. I regenerate it and click post and this warning pops again.

Right now I'm posting and I ignore the warning. So far I haven't had a problem on the machine.

 

Any ideas?

Thanks

[Guest MTB Technical Services]

Several people have reported this.

You need to rechain the geometry.

 

http://www.emastercam.com/board/index.php?showtopic=73025

[TK-32™]

Thanks.

[TK-32™]

OK, I just noticed that this happens to the very last operation that I'm trying to post.

If I try to post one group the very last OP has the problem.

 

If I try to post multiple groups only the last op of the very last group becomes an issue.

 

So I'm copying the last op, ghost it and post ignoring the dialog box.

 

In the last image you can see that after deleting Operation #16, #15 became the problem. It wasn't an issue before.