Thread Mill Arc Out Put

[kennebec]

Is there a way to get Thread mill output to out put G2 and or G3 with Z like below vs the Long hand XYZ linear type cuts

G43G54X-1.031Y-.8121Z.1H8T9M4

G1Z.028F40.

G1G42D8X-.949Y-.8121

G2X-.949Y-.8121Z-0.0033I-.082

Z-.0346I-.082

Z-.0659I-.082

Z-.0972I-.082

Z-.1285I-.082

Z-.1598I-.082

Z-.1911I-.082

Z-.2224I-.082

Z-.2537I-.082

Z-.285I-.082

G1G40X-1.031Y-.8121

G0Z.2

[kh012]

yes in the tool path parameters make sure that the "linerize helix" is unchecked.

also in the control definition on the arc setting page it should be set to allow helix's

 

HTH Ken,

[K2csq7]

It is not outputting the G2 on every line because that is modal, your control should not need it on every line....

If you need to force it out for every line, you need to edit the post....

[kennebec]

Thanks everyone,

I know about the modal G2, my post said "Thread mill output to out put G2 and or G3 with Z like below" the below sample was what I wanted and had done manually,

 

"linerize helix" is unchecked." was the answer

 

Have a Safe 4TH Everyone