Pocket not ramping on a point.

[sflow25]

I am trying to do a very simple pocket in which I want to ramp in on the center. I placed a point in the center of the pocket and chained the point like I usually would to force the start point of that pocket.

 

However, I have not been able to find a condition that will allow me to do this, and I am not sure what the issue is. When I select "align ramp with entry point" it simply ramps down elsewhere in the pocket. When "Ramp on entry point" is selected, instead of ramping, it plunges down to my center point and then starts moving outside to inside, even though I have "spiral inside to outside" selected.

 

 

I have always had success with chaining my center point in the past so I am sure I might just be missing something. But any advice would be appreciated.

[Mickey@acceltool]

Elsewhere but is it (in-line) with your point? Or just anywhere. I do it and it is in a straight line from my point in x is where it starts ramping. if you want it to plung exactly where you put your point I believe you will need to use spiral entry.

[sflow25]

Yes, it is in line with my point. Spiral entry does work correctly for me. The wish would still be to ramp, but if its not a possibility, a helix will have to suffice.