v9 HASP

[wildcat99]

Updating from 8.1.1 on Win2000 and need a little hasp help please...

 

I received v9.1sp2 this morning, installed it and just received the update codes from my dealer as he was leaving for the day.

 

I ran hasp9.exe with the new codes, but it gives me "Cannot update this HASP - check the serial number". The serial numbers match but in the hasp9.exe window it says Mill version 8 Level 3??

 

I ran Hasp Setup and tried hasp9.exe again with the same results. Any suggestions?? There has to be a simple solution. Thanks for your help.

[Craig Madsen from CM3D]

There is a updated hasp9.exe in the November Maintenance update. Click on the 'Patches' button on the top of this site, download and install the update, then run hasp9.exe - should be no problem then.

[wildcat99]

Craig:

Thanks for the quick reply, that did the trick. I guess I hadn't planned on patches until after v9 was up and running. Oh well, thanks again!