Lathe Spindle RPM set before Tool change G96 active

[abc]

MPLMaster post, X9.

 

I have the control definition set to use "Home Position" as the work coordinate selection. When using constant surface speed, at the end of the tool, it sets the spindle RPM to prepare for the next tool.

The value its outputting is incorrect. Because I am using the "Home Position" as my coordinate selection, it want to go to the position set by the machine. The Post is using this value to set the RPM, and not the next tools starting X value.

 

Can someone lend a hand with this?

[ScottBro4]

I personally have never had luck getting this to work the way you describe. This should be possible but would most likely be done through the post.