saving defaults on x8 engrave page

[cherokeechief79]

we use x8 in school because its all the laptop we use can handle.

we were running an engrave prog on a project tonite and on one of the very last moves the machine made a horrible rapid like move,ruined the part and alarmed out the has we were using.

I looked at the code and there was an arc at the end with an I of 560.9079 and a J of 2094.4913.

it didn't even appear to have an arc in the geometry on the screen in this area.

also the backplot and verify showed nothing out of the ordinary.

even watching the commands I saw no arcs.

I noticed the default parameters in the filter box were set to 0 and 2500.

I changed them to .005 and 100.

how do I get it to stay there?

also why did it seem to move in a rapid type move?

there was never a g00 and it should still have been in feed.

[cherokeechief79]

ok I found out how to save it in defaults but im still curios about the other questions.

if the has cant handle an arc that large wouldn't it give me an error rather than try to do it in a rapid motion?