editing engraving toolpaths

[BenzB]

We've been using wire-frame/letters to define our engraving geometry. This works well enough to get the job done. However, if I want to edit the engraving text down the road I have to start over. This is not very efficient.  Is there another way to accomplish this that I may not be aware of?

[Guest]

Not really, no.....

When you're using contour to do engraving, it's just geometry, like anything else you cut.....you  have to edit the geometry to change it....

This is where a macro could save time

Edited May 31, 2017 by Guest