Switching from espree to mastercam

[[email protected]]

My company is switching from espree to mastercam for the wire room. I am in in training and this is all new to me. We're having an issue trying to cut holes 1rough 3skim. There doesn't seem to be an option to cut without a tab. Right now it takes the rough pass leaving a tab. Turns off the power settings makes a move turns on the power settings cuts off tab and then machine stops. We just want it to make a full cut around and stop for the slug drop only. 

[Del.]

I don't have a newer version of MC but there was always the option to unselect tab cuts.

I did just the opposite. Went from MC to Esprit for wire.