Is there anyone who has this machine linked up to Mastercam V8 and operating. Regards PJT

Charles Thanks for your reply to my question about the xxxxor 8050 /Mastercam link up, we have the DNC software that you mentioned installed on our PC, I attemped to send a NC program generated by Mastercam to xxxxor through this but an error message called "wrong parameters" was displayed at the PC. Have you used the remote keyboard option of the DNC software? After we tried this our machine does not respond to commands from the Lathe control panel. Do you have any instructions for the DNC software? Our supplier told us that xxxxor did not produce any! Regards PJT [ 05-08-2002, 08:37 PM: Message edited by: PJT ]

I am currently attempting to set up the link between our xxxxor 8050/55T controlled Lathe and Mastercam V8, has anyone done this. [ 05-08-2002, 08:27 PM: Message edited by: PJT ]