Really you think and I7 with 16 g of mem isn't good enough to run X8 holy crap if so mastercam is going to go by the wayside. Most computers in the auto industry running full catia are I5 and doing it very well.

Hi all I was having the same issue with the level manager and this is how I fixed it. Put the level manager where you what it and then right click on the tool bar at the top, at the bottom of the drop down you will see a line that says toolbar states...left click on it and a window will open, on the left side of this window select the name of your default toolbar and then click save. This should keep the level manager open where you put it. Just switched to X6

There should be an icon on your tool bar from varisurf, just click on it to turn off or on this gnomon.

Everything in MC9 worked fine in Window 7 when I tried it, I have since upgraded to X4 and that works better in Window 7 then in XP.

Thanks everyone this works for me I knew you guys would know how.

Hi everyone can any of you tell me the easyest way to copy a level from one file to a different level in a different file. I'm using X4. Thanks in advance.

Thanks guys is this easier to do in X2 or X3

Hi everyone I have a question about MC9. Is there a way to copy a level from one Mc file to another Mc file, without having to make sure everything is on different levels then mearge them. Thanks in advance, I'm using fully updated MC9 level 3.

You can also use delite "all" or delite "only" then choose "level" and answer the questions.

Ok if you read me first message about the file has changed do you want to save message prompt when opening a file. I have narrowed it down to it only happens when you use the new file command and try opening a new file. If you leave mastercam and then reopen it the file will come in without the message. You can also fix it by turn off the prompt for the command when exiting. Anyone having this issue or any suggestion on how to fix it.

The files I'm opening are 9sp1. Its a full clean load and even after I modify the file and resave it in 9.1 it still asked that question. I can work around it but it would be nice to fix it. If I uncheck the box for the notifacating on closing I no longer get it on opening. Thanks for reading my post.

Hello everyone I have been reading this form for about a year but this is my first post. I have just updated to 9.1 and have a problem. When I open a file I get the message "file has changed do you want to save". If I answer no everything is ok, but if you answer yes it wipes out the file. The only way I have fix it is to uncheck the box in the config set up that says prompt on exit if file has changed. This is the only problem I have had so far. ps. I upgraded to mastercam 8.1 from surfcam and couldn't be happer. [email protected] or [email protected]