29 M140 MB MAX 30 L A+30 C+85 F MAX M126 31 CYCL DEF 19.0 WORKING PLANE 32 CYCL DEF 19.1 A+30 B+0 C+85 F1000 33 L A+Q120 C+Q122 F MAX When I run any program less than 90 degrees on the C-axis it works fine. Anything greater the machine wants to track the table around to position.

When I tried the spatial I get an error. I read somewhere that you have to change something in the control to allow spatial programming but I can't find it. I tried taking out line 30, when I do the x y z follows/tracks the table around. I ran some programs, T

Hi, I am working on a Deckel maho 80 P-Dyn with a tnc 430 control using a mastercam post. The machine works fine if I use 3+1 axis at one time. As soon as I use 3+2 axis like the code below it doesn't work properly. I don't know if I should use spatial plane or if someone has an example or insight I can try. The code below, line 30 rotates the table and tilts into postion but then line 32 makes the table rotate and tilt again this time x and y follows the rotation as if it is going around the outside of the table. 29 M140 MB MAX 30 L A+29.846 C+180 F MAX M126 31 CYCL DEF 19.0 WORKING PLANE 32 CYCL DEF 19.1 A+29.846 C+180 F1000 33 L A+Q120 C+Q122 F MAX 34 M140 MB MAX Any ideas?