Vikingdane
-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by Vikingdane
-
-
That's my bad, woops!
I'm trying to apply a toolpath to the wave-like surface around the pocket. I just can't seem to find a solution by myself.
-
Back again with another question
I have this part with 3D circular surface, but after much trying and frustration, I cannot find a proper way to apply toolpaths. The toolpath keeps digging into the hole in the middle of the part.
How would you do it?
-
Thanks once again
I just need to play around with planes some more to it just right.
-
Thank you! That is exactly what I was going for
I was a bit confused at first because I couldn't open the parameters (I got an error where it reset all the parameters to default. But I found the toolpath you were talking and it all worked out.
I have a couple more questions if you don't mind:
Which toolpath would you use to rough the part?
What would the rotary toolpath be better for?
-Thomas
-
Hi
For the past few days I've been messing around with the rotary toolpath, and so far I have been able to apply it without any major problems.
Here's my problem: When I generate the toolpath and want to verify it, the tool starts at the chuck and moves towards the origin.
How can I change the starting point so the tool starts from the origin and moves in the X positive direction?
-Thomas
3D roughing on a circular surface.
in Educational Forum
Posted
That's exactly what I'm trying to do
Unfortunately, I can't open MasterCam right now due to me being away from the network that is hosting my license.
EDIT: How did you create the surface you used as a drive for the blend? Also, how would you rough it out before finishing it? That is my main question.