My zero is on the top of stock. Perhaps later when I can get into the lab at my school, I can take some screenshots and show the problem that is occuring. Both depths are set to absolute -.1875". I can check the length comp, not sure if I checked that or not.

Hi, I am trying to pocket out a small sqaure on a cell plate. The pocket is .1875 deep. I am also contouring a channel that will lead into the pocket. I set both depth cuts to .1875 but when I run the simulation, my contoured channel is always deeper then my pocket. I have no idea why this is happening and have tried a few things but found no success. I even modeled the entire program over and I am still having the same problem. Anyone have any solutions to this problem, it seems simple but I cannot figure it out.