HEADING
-
Posts
4 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by HEADING
-
-
also i have entry level mastercam do i need to upgrade to lv 1 ?
-
i see them but which one do i select for boring an id? they all look like od settings. the part already has the finished form in it im just skimming it in the hard state so taking out like a few thousands.
i used bobcad in the past and you simply select the line and as long as your tool has clearance it made the tool path for you. thanks for the response was very fast.
-
Hi could anyone help please twice now once on the od and now the id I have run into problems trying to run a finish pass were the tool must dig in along the diameter. I have changed the entry angle and tool angles and know these movements are possible. for example i'm doing a 3.476 id diameter and wish to travel at 2 degrees to a 3.544 id diameter my 431 cnga bar has plenty of clearance to achieve this movement but no mater what I try it wont, it just cuts straight. The od movement was only .002" for an undercut on the od. Is there a setting i need to turn on these are finish passes forms turned soft and h/t then trying to skim one pass hard to finish.
lathe tool path
in Industrial Forum
Posted
problem solved was the back relief angle. i put a value of 5 degrees i was suppose to un check the box. now its working fine thanks