Hi all, I am new to mazak matrix 2 controllers. I am trying to use G54.4 (dynamic work offset compensation). The goal would be to define a work offset in G54. This would be a location on the corner of the raw material relative to the center of rotation of the machine (G55). To machine the first part on the table I would call G54.4 P1. I would then like to use G54.4 P2 to machine the 2nd part on the table. If I wanted to rotate the table 180 degrees to machine the 2nd part, where should the work offset be for the 2nd part and where do I put the value for 180 degrees in the G54.4 P2 offset. I have done several tests on the machine and it does not seem to be taking into accout the 180 degree rotation for the 2nd part....? I tried putting the value of 180 in both the C and delta C location in the G54.4 P2 and the machine does rotate the c axis 180 degrees when performing machining for 2nd part. Any help would be appreciated. Thanks!!