I have been playing with my post and can not get it to separate the Z move from the x and y in its initial position move when using multiple tools or a forced tool change. The first tool works great but if using a forced tool change or multiple tools bam the x,y and z are back in the same line after the G94. Below is the example this situation happens using 2 tools. Attached is my post any help or suggestions would be appreciated. Thanks. % O0000(T) ( T1 | 1/4 FLAT ENDMILL | H1 | D1 | WEAR COMP | TOOL DIA. - .25 ) ( T2 | 1/4 CHAMFER MILL | H2 | D2 | WEAR COMP | TOOL DIA. - .25 | XY STOCK TO LEAVE - -.01 | Z STOCK TO LEAVE - 0. ) N1 G90 G54 G64 G50 G17 G40 G80 G49 N2 G20 N3 G54 N4 M8 N5 M998 N6 T1 G43 H1 M6 ( 1/4 FLAT ENDMILL | TOOL - 1 | DIA. OFF. - 1 | LEN. - 1 | TOOL DIA. - .25 ) N7 S3500 M3 N8 G0 G94 N9 X-.005 Y.135 ----------------------------------------------------------------------------------------------------------------------------- (Here it is fine) N10 Z.1 N11 G1 Z-.1 F30. N12 G41 D1 Y.13 N13 G3 X0. Y.125 R.005 N14 G1 X1.9297 N15 G2 X2.0547 Y0. R.125 N16 G1 Y-1.1602 N17 G2 X1.9297 Y-1.2852 R.125 N18 G1 X0. N19 G2 X-.125 Y-1.1602 R.125 N20 G1 Y0. N21 G2 X0. Y.125 R.125 N22 G3 X.005 Y.13 R.005 N23 G1 G40 Y.135 N24 G0 Z.1 N25 M9 N26 M5 N27 M8 M01 N28 M998 N29 T2 G43 H2 M6 ( 1/4 CHAMFER MILL | TOOL - 2 | DIA. OFF. - 2 | LEN. - 2 | TOOL DIA. - .25 ) N30 S3500 M3 N31 G0 G90 N32 X-.005 Y.125 Z.1 ----------------------------------------------------------------------------------------------------------------------------- (Here it is back to placing them in the same line) N33 G1 Z-.125 F30. N34 G41 D2 Y.12 N35 G3 X0. Y.115 R.005 N36 G1 X1.9297 N37 G2 X2.0447 Y0. R.115 N38 G1 Y-1.1602 N39 G2 X1.9297 Y-1.2752 R.115 N40 G1 X0. N41 G2 X-.115 Y-1.1602 R.115 N42 G1 Y0. N43 G2 X0. Y.115 R.115 N44 G3 X.005 Y.12 R.005 N45 G1 G40 Y.125 N46 G0 Z.1 N47 M9 N48 M5 N49 M998 N50 M30 % MACH 3 AXIS MILL.rar