treej250
-
Posts
4 -
Joined
-
Last visited
Never
Content Type
Profiles
Forums
Downloads
Store
eMastercam Wiki
Blogs
Gallery
Events
Posts posted by treej250
-
-
Im currently using the MPA2100E.pst for a PC2100 control. I keep getting an error on the machine when the program starts to do a helix move. I notice the mpmaster.pst has some info in it concerning this. Do I just use the mpmaster.pst instead of the MPA2100E.pst? or do I need to copy some info from mpmaster.pst and paste it into the MPA2100E? Im not sure how to go about this.
Thanks for your help.
-
You may be right. I do notice that all the digits on the control for X, Y, and Z are to 5 place decimal accuracy, and the post is outputting to 4 places. I wonder why my control is showing 5 places after the decimal? I cant machine that close.
Mark
-
Is there more than one post processor for the Acramatic PC2100 control? I cant seem to make the only one that comes with MasterCam work. It will post out fine, but when I run the program on the machine I get an error message at a arc move. G2 or G3.
thank you.
Mark
Backplotting with MasterCam Lathe
in Industrial Forum
Posted
Im planning on purchasing a Haas TL-1 lathe and Mastercam. Ive noticed on the mastercam demo's that when backplotting they always show the tools from the back side of the lathe. The TL-1 lathe is setup like a manual lathe where the tools are cutting from the front. Is it possible in Mastercam to show the tools cutting from the front when backplotting?
Mark.