Search the Community
Showing results for tags 'RECOGNITION'.
Found 1 result
-
Is it me or is anyone else fed up with using mastercam? We have X7 here in the shop and we use it for primarily turning operations and for god sakes I waste more time trying to figure out how to circumvent the minor quirks in this software's ability to function properly. Now I'm have a problem with its stock updater. Im Drilling a 3.5" hole in a 18.675" X 10.5" piece of stainless, then facing an 1" off the 1st side, then coming in with a 2" boring bar and rough turning a lot of stock off the I.D. Its telling me the tool starts embedded in the stock, however, its been faced off, so why doesn't it recognized that? I should not have to start a whole inch off the face of the damn part cutting air. Someone please help. Ill try to include the file 1356 OP20.MCX-7