Search the Community
Showing results for tags 'post editing'.
-
Can anyone help me out in the following three problems in editing a Mastercam post in this community please? 1. I am working on creating a new post for an Okuma lathe by editing a Fanuc post (simply because it is available to me) and getting to the hard part. In canned cycles, I could replace the G code, the P code, and the Q code in the canned rough cycle output to make it changed to G85 NTRY U.1 U.02 W.01 F.01 G84 NTRY G81 N100 ... ... The first U code is the depth of cut and supposed to be D in Okuma. This U for depth of cut can be found in the "Canned cycle output format" table in the post and I did have it changed to D. I also successfully had it output after the heading. It showed as a D for sure. However, in this rough cycle output line it still shows as a U . 2. In the above case, I found no place to remove the N100 in the third line which is what Okuma does not like. 3. In the threading output as shown below G33 X1.7354 Z-2.9769 P1323 Q518 R0. E.22222 there is an E code. I guess it means a precise feed rate in Fanuc. But it is lead variation in Okuma. I therefore have to replace it with an F. However, I could not find any E in the "Thread output" table in the post and thus not able to replace it. Your help will be greatly appreciated. Thank you.
-
hi, guys anybody can help me in removing g54 in lathe post?
Join us!
eMastercam - your online source for all things Mastercam.
Together, we are the strongest Mastercam community on the web with over 56,000 members, and our online store offers a wide selection of training materials for all applications and skill levels.