Newbie. Experimenting with Learning Edition. 1st attempt at custom tool. "Problem with custom geometry data - line segment on Y axis." NM Figured it out. Not sure how to delete the post?

[tightmf]

I did the blue shank and red cutter on NOCUT and CUT levels respectively.  It's line up along the z axis.  The cutter proflle goes into the y axis so I thought I'd rotate it into the x axis but I got an error "There is nothing is there" essentially.  Has anyone encountered this?  Thanks.

Edited June 11, 2023 by tightmf

[AMCNitro]

You answered your own question.  It needs to be drawn on the TOP plane regardless of the axis it's going to be used on.