Where is “Enhancing Model” feature in Verify? - Mastercam 2023

[M Ham]

I just rolled from Mastercam 2021 Update 1 to 2023 Update 4. “Verify” graphics don’t appear as crisp as 2021, particularly when “zoomed” in. In 2021 there was a progress bar labeled “Enhancing Model” that would continue to improve the appearance as you wait and/or move your part around.

 

My question:

Is this function still available, and if so, how do I enable it?

 

Thank You,

Mike

[SuperHoneyBadger]

Noticed in 2024's Sim I need Verify>Quality>Accurate Zoom a fair bit more than I did with 2022 to see that crispiness. Also, leave Turbo Mode off in the same area, and try jiggling with the Performance - Precision slider right of the transport buttons at bottom middle. Might help some with your initial views.

Also, don't forget Reset Zoom once you have used Accurate Zoom, as it cuts off what is outside of your current view

[sharles]

OK, I've been using 2024 for a couple weeks now and I've had the "Enhancing Model" bar down at the bottom of Verify...until a little bit ago...then it just vanished. How do I get it back?...never mind, I found it...

[Jobnt]

38 minutes ago, sharles said:

never mind, I found it...

... ??