Stock not updating correctly

[NicholasFell]

Hi all, ive had this issue a few times, not sure how to resolve it, stock is only updating what the tool cuts below the centre line, any help?

 

[AHarrison1]

Do you have a file to share?

Goto File - Zip2Go.

That way others can see what you are seeing and offer better help and possible solutions.

[NicholasFell]

5 minutes ago, AHarrison1 said:

Do you have a file to share?

Goto File - Zip2Go.

That way others can see what you are seeing and offer better help and possible solutions.

Thanks, file attached, FYI any advice on anything here would be appreciated.

MPF0635_OP2.ZIP

[AHarrison1]

I don't have 2019 loaded anymore but in 2020 and 2024 I went to stock settings and just cycled through the tabs in properties.

This caused the facing op to go dirty, re-executed face op now it is all good.

[NicholasFell]

3 minutes ago, AHarrison1 said:

I don't have 2019 loaded anymore but in 2020 and 2024 I went to stock settings and just cycled through the tabs in properties.

This caused the facing op to go dirty, re-executed face op now it is all good.

No luck, I cycled through the stock setup options, deleted the stock, and re-selected it, but issue is still there.

[AHarrison1]

Create a new facing op.

I'm guessing that all those ops were from op1 ported over to op2.

Sometimes the ops still stay tied to previous stock which is why they sometimes don't show the stock being updated.

You said you created new stock so the problem may be the op itself.