adding values to diameter offsets

[hawkeye]

Hello once again,

In the job setup menu, there is a field that allows you to add to your diameter offsets. The problem I have found is when you add, for example "10" to the offsets, do the toolpath, then, for whatever reason, you must add "20" to the offsets, it won't update the existing toolpaths. Is this a problem with MC or am I possibly overlooking something? (as does happen more than I care to admit!)

[Ambassador]

Hawkeye, you will need to reselect the tool in each operation, after you change the offset number in the Job set up. You should notice that the Diameter or Length offset will change in that operation when you reselect the tool. Hope this helps.

Ambassador