surface q

[s0l0seven]

hay guys,

 

can one of yens help me out. i am trying to draw a surface that starts flat and then goes on a ten deg angle on the face of round stock. what are ways i can go about this. heres a picture here the red is the angle and boundry and the green is were the angle starts Well i will have to email you yhe picture if you are interested. thank you

 

[cadcam]

Put the picture on the ftp so every one can get it.

Plus i would like to see what you want & help.

------------------

jay/ aka cadcam

Precision Programming

cnc programming &

Predator & mastercam reseller

email: [email protected]

web: www.ppcadcam.com

[cadcam]

soloseven check your mail.

to get this file

------------------

jay/ aka cadcam

Precision Programming

cnc programming &

Predator & mastercam reseller

email: [email protected]

web: www.ppcadcam.com

[This message has been edited by cadcam (edited 07-10-2001).]