Rotory axis defaults to "Y"

[Allen P]

When I am doing a C axis cross contour, I go to the tool parameters page and open the "rotory axis" page and click "C". When I regen the path, it defaults back to the "Y" axis switch. This has only happened since I set up a new computer. When I generate code, it posts out "C" where it should.

 

Can someone point me in the right direction so I can adjust this? I have most of the other issues (new computer) figured out.

 

Thanks for your help

 

Allen

[Jean-Simon]

Go to screen configure under NC settings tab, on the bottom left go to operation defaults click on save and then go in the "c" axis lathe toolpaths in cross contour and all what you change there are defaults. HTH!

 

Simon