Surface Finish Contour Error.

[ChrisD]

Good morning,

 

We have been using the shallow and flats feature in the Surface Finish Contour aka(SFC) tool paths. We have three seats of level three with solids. On two of the computers in the SFC

Finish Contour Parameters page there are three buttons : Helix (greyed out usually), Shallow, and Flats. On the one computer that we have only Helix and Shallow.... no Flats button. Is there a patch that we may be missing for this? We tried reinstalling the software but to no success.

 

Any ideas?

 

Thanks

Chris D.

[zoner]

Have you tried tpcfg.dll in your chook directory.

Enable flats hth.

[Paul McGarr]

I believe you need to run the tpcfg.dll chook to get flats to show up.

 

Paul

 

Damn! Too late again.

[ChrisD]

thanks guys it worked