Message 28

[Rick McAllister]

Happy Tuesday All,

Little problem....

I have a 4th axis helix. I'm using Curve 5 Axis with y as the rotary. My initial path is good but I want a spring pass. When I turn on Multipasses, Finish Passes set at 2 at .002, then regenerate I receive a “Message 28 in [msurf5ax] not found”. Does anyone know if this is something to worry about? Code looks O.K.

[Lee.]

Rick,

 

A safer bet would be to copy your op twice, using different stock to leave values.

 

HTH

[Rick McAllister]

Thanks Lee but it sounds Like a workaround.

[mcpgmr]

Might sound like a work around but you have more control over the fin pass. You can change speed and feed and various other parameters using this method. I do it all the time. JMO

[gavetta]

I'm with Lee and Paul on this one also. I even do it on multi surf too after rough pocket if I want to rough down with bigger step over and faster feed, leave stock for the finish pass . I don't trust anything that gives me an error message.

[Lee.]

Thanks Paul and Gav.

 

That was my logic behind saying that.

 

More Control.

[Rick McAllister]

Thanks for the input everyone. I tightened up the Curve Cordial Deviation in my configuration menu and the mesage went away. I think it was causing the cutter to touch a check surface.

 

Good Day....