Lost comment during transform?

[5 AX]

When I tranform my toolpath the comments do not post. Is this a transform issue or a post issue?

[Mike Whitten CAD/CAM Contractors]

I believe that this is an X issue and have submitted this at least once. It would be a good idea to submit it again though.

 

Mike

[P_Scott]

5 AX,

 

What are your Transform Operation parameters? I found that if I Copied the source ops and disabled the posting with those ops, their individaul comments were not posted. However the commment from the actual Transform operation was posted. When the source operations weren't Copied from within the Transform operation and were selected to be posted, the individual comments from the source ops were output. This indicates to me that it may be related to the post processor or default NC output settings than a "bug" with the software. HTH

[mtnflyr]

I've been having the same problem using Transform Operation using Copy source operations setting and Disable posting setting. When choosing this type of Transform Operation any comments in the program including header notes are not posted. Along with this problem using Transform causes the program to error and shut down.

I understand there is an SP update on the way. Does anybody know if this update fixes these problems?

[Paul Decelles]

Yes folks, it is a bug and it is being addressed. Unfortunately it did not make the SP1 build so you most likely will not see the fix until MR1.