Rough Plunge Question

[cadmonster66]

Could Some-one please tell me is there a way to use the tool boundries setting in the rough plunge.On the computer I'm using the setting says it is disabled

Could you tell me how to turn it on.

The reason I'm asking is because i have an irregular shape cavity and the path will run but it goes outside the cavity when i use stock to leave on the drive surface/give it a cut tolerance of .002/ and also use the check surface

thank you

John C.

 

[Fred from Université de Sherbrooke]

Have you try to play with cut depth. Put it in absolute a set the minimum depth just below the top of your piece.

[Toby]

You might have to create a flat surface boundary before that will become active.