Windows XP Problem

[Karl@CP PISTONS]

Hi all,

It's late so if this has been answered already please forgive..

I just got XP installed but mastercam hasp will not install correctly. I keep getting a error writing to the registry. I tried manual hinstall -i but still no luck! No one else i spoke to had any trouble with XP.

P.S. I am set up as admin

[cadcam]

You will need to down load these hasp drivers and install them in the Mcam8/Common dir and run them again from there reboot and try mastercam.

Here is the down loads.

hdd32.zip

hinstall.zip

these are zip files so you will have to unzip and replace the ones in the common dir when prompted to.

Ok, I all so put a set on the FTP under Patchs 8.1.1.

but the upper link down loads them direct.

[ 11-06-2001: Message edited by: cadcam ]

[Karl@CP PISTONS]

Thanks a million... New hasp drivers fixed all problems. i was ready to give up and go home, now I gotta finish this project.

[cadcam]

Well glad i could help.

[Guest CNC Apps Guy 1]

Any official word from CNC about development on XP???????

 

Just curious.

[cadcam]

Ya they said some thing like "X"tra "P"ane in the ***

But i have to say some of the time that i have plaed with it.

It was not to bad at all.Not sure if i am ready to move full time to it yet.

I have installed full time on my wife computer but she does not do much mastercam.

[ 11-06-2001: Message edited by: cadcam ]