multi pass help

[CH]

I'm trying to program a part in 10 the same way I did in 8 and its not working. Here's what I'm trying to do.

I want tool path down one side of a part 1 mm big and 14 mm deep. Then I want to move over 1 mm on the X , Z down 5 mm more and then come back the opposite direction. I want to do this without creating any geometry and only creating one chain. I was able to do this in Version 8 using Ramp (Plunge set at 7), Multi passes (rough passes 1 spacing 0) (finishing passes 1, spacing 1) with final depth and tool down both checked. Then I would need to have my top of stock set at -9. and depth at -14. These settings would make my first pass 14 mm deep and the second pass 19 mm deep. I can not make this work the same way in X.

Any suggestions on how I can go about making this work?

[Guest]

Linky

 

See if that helps