WARNING-Y AXIS MOTION

[MasterCAM Rulez]

i get this signal when i'm running lathe MPLFAN post -->

"WARNING-Y AXIS MOTION AND (Y_AXIS_MCH)NOT SET"

I THINK IS THE "MPLFAN" POST PROBLEM.BUT I'M NOT SURE HOW TO FIX IT.

CAN ANY1 SHOW ME HOW?

THANX IN ADVANCE :

[ 01-19-2002: Message edited by: MasterCAM Rulez ]

[ 01-20-2002: Message edited by: MasterCAM Rulez ]

[MasterCAM Rulez]

i just fixed the problem. this is how do it

when your machine supported the y-axis you must need to modified the post, tell the post

that your machine supported the y- axis. or else you will receive the following error

messaged

"WARNING-Y AXIS MOTION AND ('y_axis_mch') NOT SET"

 

Following the following instruction it will fixed problem

 

1. Go to

 

# Machine Specific Settings

# --------------------------------------------------------------------------

#Machine axis switches, initial

y_axis_mch : No #Machine has Y axis, 0=no, 1=yes

2. From "NO" change to "YES" that mean you want the post to know that your machine supported y-axis

 

y_axis_mch : yes #Machine has Y axis, 0=no, 1=yes

 

That's it. it should be OK now

[ 01-19-2002: Message edited by: MasterCAM Rulez ]

[ 01-20-2002: Message edited by: MasterCAM Rulez ]