mask not working with points

[bb]

i have set mask by level using select only button and checked the maintain mask box.masking is working for lines on other layers but i can pick point entities that are not on the mask layer.have i setup the mask correctly or is a bug causing this

[Colin Gilchrist]

bb,

 

I'm not quite sure at this point. The "Only" level option is working fine for me with point selection. If your "Only" mask is turned on you should see an asterisk (*) on the button. If you are still getting the error, try running RAM saver. It might help clean up your file. Also, any time you notice Mastercam behaving strangely, save your file immediatly and shut Mastercam down. Then restart Mastercam and see if the strange behavior is still there. Usually this fixes a lot of problems.

 

HTH,