posting

[toolall1]

o.k guys any help would be appreciated.

this happend 2 times so far.if i add a toolpath or alter a tool in a toolpath and re-gen,i go to post out and lets say i pick 3 toolpaths one is the new one i just added.mr2 goes through the posting but drops the highlighed new path, and i checked the code and shure enough it skips it.i think m-cam just gets minde screwed and has trouble here.if i redo all 3 paths of that spacific tool then of course it works.this is a pre existing file.also like adding surfaces to the toolpath or deleting some then a re-gen and say add a path triggers it also.

[John13]

Is your NC filename the same or does it change with the new toolpath

[toolall1]

same

[toolall1]

same group same tool just a new path and it gets lost on the out post.if i select them and verify the toolpaths look fine.

[Guest]

select all your ops with in the operation>> right click >> edit selected ops >> rename nc file, then try it.

 

If that doesn't work, send it off to QC because there is something wrong but I don't believe that's the problem

[toolall1]

thanks john

[specv]

Happened to me this morning and it was the NC filename. I believe this is the same problem in v9 as not having the same nci path. correct?

[Guest]

for all practical purposes, yes, it is the same problem

 

BTW, starting in I believe X MR1, there was an option of file naming made available under settings >> config >> toolpath manager.

 

Setting this up and using it helps to allieviate this issue that keeps cropping up

 

hth

[toolall1]

select all your ops with in the operation>> right click >> edit selected ops >> rename nc file, then try it.

that worked thank you John have a good day

[Guest]

Your welcome,

 

GTH