Lahthe Control, Def, Pst problem.

[kunfuzed]

I want to copy these files and modifiy them:

 

LATHE 2-AXIS SLANT BED.LMD

GENERIC FANUC 2X LATHE.control

Generic Fanuc 2X Lathe.PST

 

I've done it two diferent ways. First just copying and renaming each one manually in Explorer in the same folder, and then I've followed Streaming Teacher by opening the original and saving as a new file name.

 

EDIT: I've also been linking each pst to def to control as I believe I should.

 

Here's my problem. I draw a simple part, give it a canned rough cycle, and a canned finish cycle, and with the original un-modified files above, it posts just fine.

 

But after I copy the files (with out any changes) I try to post and get the warning: WORK OFFSET IS CHANGED IN A SUBPROGRAM. And then the toolpaths don't post correctly.

 

Any ideas?