lost my snap!

[TEX123]

Can anyone help me please?

 

I'm running mastercam 9.1 MR0105

 

Anyway in Mill, I've recently completely lost my snap, it wont highlight when I move the cursor over a curve. I've tried it in Design, and it works in that.

 

Is there a setting that I may have messed with to take it off?

 

Thanks

[G Caputo]

From main menu > screen > configure. at the top right hand side of the system cionfiguration, hit the screen tab. on the left side of the page is "Use Auto-Cursor in Point Selection" checked?

[TEX123]

haha, thanks Caputo, just found it, was just going to post a reply that its now sorted