Haas EOB needed

[Sandybar]

I did a search and could not find what I'm looking for. Don't flame but we purchased a

Haas, using the MPHAAS post, downloading it to the hard drive and errors out with a "unknown Code".

 

We put in EOB manually and then accepts program. How do I get the post or Master Cam to put in the EOB characters in without puting in manually.

 

Thanks

[mgsanchez]

You may want to check Setting 25 "EOB Pattern" on your Haas control and make sure it is set for "CR LF"

[Sandybar]

It is set at "CR LF" And and still not accepting programs. What does CR LF mean?

 

Thanks

[Guest]

Carriage Return

 

Line feed

[mgsanchez]

The only other thing that causes problems is a "%" missing at the beginning and/or end of your program.

[mgsanchez]

Also make sure the "%" only thing on the line.

[Merdoc]

I am having problems using the UpdatePost.dll with MX2.. I have a V9 post that i love but cant get it to run in MX2. Can anyone help me out with this????

[Guest]

Merdoc,

 

How about contacting your reseeller?

[Merdoc]

i tried contacting them and they have not returned my phone calls...

 

SO..... I am here now hoping to get some help. Should i call MasterCam support or will they tell me to go through my reseller??

[Merdoc]

When i run the UpdatePost.dll it comes back with "the post has been processed with UpdatePost to the current version and will not be re-processed! Enable debugging in the NC Output page of the post's Control Definition to debug/verify an update post." So i enabled debugging and then tried to add the post in Control Definitions Manager and it says its added but will not be saved.. I am stuck. Can anyone help???

[Guest]

Mail Merdoc