Resolution of the model during verify

[tbriggs]

When I verify a toolpath on a cylinder the cylinder does not appear very round. It looks like it is an "n" gon with about 60 sides. Is there a setting for this?

 

Thanks!

[Guest]

To make the change permanent do this,

 

Go into settings config and change this setting

 

 

To make the change ONLY for the session you are currently working in do this, start your verify, on the verify dialog, click on the yellow folder

 

then make the setting change on the next page

 

 

 

either way you do it .001 is the tightest you can make it