Transfer Toolplanes Posting question

[[email protected]]

Hello All,

I am running 4 parts on a HAAS VF3 using G54 thru G57. I am using the post from Fastech and it is posting correctly, but I want to change my sub-program #'s in the post if possible.

Right now my sub #'s are o0001 thru o0028 and I want it to start at 1000 and count down because I already have programs in the controller starting at o0001 and going up.

 

Is there any way possible to achieve this?

 

Thanx

[Guest]

code:

---

 psub_call_s$     #Call to sub level

result = nwadrs(strp, sub_prg_no$)

sub_prg_no$ = sub_prg_no$ + 1000 #Add sub number offset

if progno$ = sub_prg_no$, result = mprint(sprgnerror)

pbld, n$, "M98", *sub_prg_no$, e$

---

You could go into this section and hard set a value or use a misc int to get a value in and then use the included math to add up or down.

[[email protected]]

I'll give it a go,

Thanks JP

[Rob @ Target Machine]

Just keep in mind that this "offset" used to shift sub_prg_no$ needs to be a static number so Mp.dll can recall a sub number previously used.

 

This "recall" feature is common to depth cuts and drill points posted as subs.

[Rob @ Target Machine]

BTW - Congrats for reaching 200 posts. You are now deemed worthy of a avatar. I'm almost there. 10 more to go.