Misc. Int Hiding?

[Mic6]

I set up a misc int. for my chip auger. If I post the one operation I want it on in, it works fine. If I post more than one operation, even if it's the same tool, it won't show up. What gives?

 

 

1 OP

 

 

code:

---

 %

O1111( 20123592-005-1 )

( T21 | INGERSOLL 2" FACEMILL | H21 | D21 | DIA: 1.9965 )

G20

G0 G17 G40 G49 G80 G90

G91 G28 Z0 ( ROUGH POCKET X,Z +.008 )

T21 M6 ( INGERSOLL 2" FACEMILL | T: 21 | D: 21 | H: 21 | DIA: 1.9965 )

G0 G90 G54 X2.8737 Y-6.7665 C0. S8000 M3

G43 H21 Z.1

M31 (CHIP AUGER ON) <---------------------NOW i SEE IT

/M8

G1 Z-.0365 F50.

G41 D21 Y-4.77 F100.

---

Two Ops

 

 

code:

---

 %

O1111( 20123592-005-1 )

( T21 | INGERSOLL 2" FACEMILL | H21 | D21 | DIA: 1.9965 )

G20

G0 G17 G40 G49 G80 G90

G91 G28 Z0 ( FACE STOCK TO ZERO )

T21 M6 ( INGERSOLL 2" FACEMILL | T: 21 | D: 21 | H: 21 | DIA: 1.9965 )

G0 G90 G54 X8.6431 Y-6.0587 C0. S5000 M3

G43 H21 Z.25

/M8 <------------------NOW I DON'T

Z.1

G1 Z0. F40.

G41 D21 X8.6417 Y-4.7609 F50.

G3 X0. Y3.8717 R8.6417

X-8.6417 Y-4.7609 R8.6417

G1 G40 X-8.6431 Y-6.0587

G0 Z.25

M9

M5

G91 G28 Z0.

M01

( ROUGH POCKET X,Z +.008 )

N21 G91 G28 Z0

G80 G49 G40 G20 G17

T21 M6 ( INGERSOLL 2" FACEMILL | T: 21 | D: 21 | H: 21 | DIA: 1.9965 )

G0 G90 G54 X2.8737 Y-6.7665 C0. S8000 M3

G43 H21 Z.1

/M8

G1 Z-.0365 F50.

G41 D21 Y-4.77 F100.

G3 X0. Y-1.8963 R2.8737

X-2.8737 Y-4.77 R2.8737

---

[CNCGUY]

It would have to be saved to be used again or turned on in each operation.