Techni Waterjet PAC55/Anca Control

[Mick]

Is anyone out there using one of these watercutters, with Mastercam?

 

If so, whereabouts did you obtain the posts processor from, and does it function well?

[Chris Parish]

Mick:

 

I have written several for water jet / laser cutters....

 

Usually I get sample programs from the machine that ran... then I start to build a specific post from the information supplied...

 

I also ask for a manual if they have one

 

Hope this helps

[Mick]

Thanks for the reply. That very well may be the case, in that there probably isn't a post out there that anyone can supply.

 

I need to have a look at the programming for the machine, and the manual (as you suggest) and take it from there.

 

Sounds like it might be a visit to Inhouse for this one